!!!ATTENTION!!!
DESIGN FLAW, BODY WON'T FIT LAMP SOCKET BECAUSE OF THE HINGES ON THE BOTTOM OF THE BODY WHERE THE LEGS SHOULD BE ATTACHED WITH THE BOLTS.
[there is a practicable workaround though see pictures for ideas [the water ist around 60degree celsius] when bending back in a swift motion after mounting it on the lamp, try to align the joint as good as possible, cause later bolts should fit in] ////////////////////////////////////////////////////// ////////////////////////////////////////////////////// Please print following set of four for most actual building pleasure:
-Creeperlamp legs45RC2 -Creeperlamp boltsinlaylid RC2 -Creeperlamp body RC2 -Creeperlamp headRC2
[2023-10-03] ////////////////////////////////////////////////////// ////////////////////////////////////////////////////// !!!ATTENTION!!!
A friend of my kid is fascinated with 3d printing and asked for a minecraft creeper lamp. I had one old ikea lamp and designed a cr33p3r with Fusion360 for it.
If you want to print and assemble one you will need to print following part sets: ////////////////////////////// boltsinlaylid body head legs for the lamp as intended ///////////////////////////// boltsinlaylid body head legs thinner / thinner duo45 for the lamp slighlty lighter [this option is WIP] /////////////////////////////
'legs thinner' are all four legs not orientated in any way,
'thinner duo45' are one set of left and right leg, each one sitting on the most inner corner so that support would touch only the least visible surfaces.
The final design is visible at the second picture, the one where only the dismounted parts are visible. 3D printing settings
first testprint is a marathon of a few days, i will update this description until completely printed and assembled.
-head printed flawless -body printed flawless [without supports] [body needs to be heated