EXIT Triker Pro100 Flagholder

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3659436.

// missing information / photos will be added soon // ( gibberish will be removed and nearly proper sense will be added too :) )

This is a spare part for the

'EXIT! Triker Pro 100'.

The visibility flag holder, which is located on the rear left axle, rusted away so it needed replacement.

Hence i plan to integrate also a rearlight at my sons Triker, i replaced the entire lower endcap of the frame, the one without reflector.

This part fits veeery tight and needs some careful hits to secure it fully in the frame. It is this tight by choice, the first one sat tight in there, but was too flimsy and fell out while my son was in 'stunt mode'.

In the design of this replacement is a hole, where a bolt could be inserted, on this bolt / pole i put some rubber rings and slid a small aluminium pipe over it.

I had some orange truck tarp(?), cut two small slots in the near of two opposing corners on one side, inserted the pipe / pole through the first one, inserted another bolt with a washer through the second slot, added another washer and put that assembled bolt into the top end of the aluminium pipe.