Headphones wall hanger.

Because we don't like headphones sitting randomly on a table. They just look bad, right? :)

This helps tidy your room or workspace and should work for a wide variety of headphone models.

This design does not have holes to fix the part using screws, we used a 3M VHB-ish tape instead, which provides a reliable hold. We have had a couple of hangers around the house for months and they are holding up just fine. Make sure you use a reliable adhesive to fix the hanger to the wall

There are 3 different sizes available:

• 35 mm
• 50 mm
• 70 mm

If you would like us to add a screw-mounted version, let us know in the comments ;)

Print Settings You can print this at any layer height, with 10% infill. We used a 0.4 mm nozzle. The print requires no supports.

Follow us / support Did you like this design? Follow us on Instagram! We are @twothingies

If you print this, let us know! Tag us on Instagram and we will feature your print :) Or you can leave us a review here. It really helps us improve our models 👍

If you really like what we are doing and want to support us, you could buy us a coffee or two!

Selling prints of our designs Please be aware that our designs are available for free for non-commercial purposes only. If you would like to sell 3D prints of our designs in your store, you can join one of our membership tiers!

If you have other ideas, we would be happy to hear from you! Please send us a message.