This is a 3D printed adjustable strap to be used for purses, bags, accessories, etc.

The strap needs to be printed in a flexible filament. I've had success with a range of shore hardness levels. I think my personal preference is in the 85-90a range.

The hardware is to be printed in a rigid material. I prefer to print the hardware in HTPLA, PETG, or PLA+.

There are three versions to choose from. The first uses E6000, superglue, or your preferred adhesive. The second uses 6mm cap width x 5mm post length rivets, although similarly sized rivets can work as well. The third uses a simple saddle stitch technique to sew the ends together after the swivel clasp hardware has been attached.

It takes around 3 hours to print and 5-10 minutes to assemble.

Please refer to the photos and video included for additional guidance on how to assemble these straps.

If you have any questions, please send an email to Kaizen3DPrints@gmail.com