The PC version of this game was released this week, alongside this beautiful graphic - I couldn't help but give it the good ol' Hueforge treatment!

This one uses 8 filaments, but grey is swapped twice so that's a lot of swaps if you don't have 2 AMS. The 3MF will have the swaps already loaded in - if you do not use the 3MF, please feel free to use the STL and follow the instructions below!

Print Instructions Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

The Model is 245.17x240mm in size You may print at higher layer heights below the Min Depth of 0.4mm The Max Depth is 2mm and the Actual Depth is 2mm

Filaments Used:

• PLA BambuLab Matte Charcoal Transmission Distance: 0.6
• PLA Chrominal Penumbra Gray Transmission Distance: 7.4
• PLA BambuLab Basic Red Transmission Distance: 5
• PLA CC3D Orange Transmission Distance: 6.5
• PLA CC3D Lemon Yellow Transmission Distance: 6.8
• PLA eSUn Cool White Transmission Distance: 2.7
• PLA Chrominal Serpent Green Transmission Distance: 8.2
• PLA BambuLab Basic BambuLab Green Transmission Distance: 2 This print uses 8 unique filaments

Swap Instructions:

• Start with Charcoal
• At layer #11 (0.6mm) swap to Penumbra Gray
• At layer #15 (0.76mm) swap to Red
• At layer #20 (0.96mm) swap to Orange
• At layer #25 (1.16mm) swap to Lemon Yellow
• At layer #26 (1.2mm) swap to Cool White
• At layer #29 (1.32mm) swap to Serpent Green
• At layer #33 (1.48mm) swap to BambuLab Green
• At layer #35 (1.56mm) swap to Penumbra Gray
• At layer #40 (1.76mm) swap to Cool White for the rest.