A paddle‑surf can holder designed to keep a standard aluminum soda can firmly secured under the board’s bungee cords. Two sinuous lateral grooves allow you to thread the board’s flexible cord from the rim down into a locking notch beneath the base of the cylinder, fixing it solidly to the deck and preventing any movement or tipping during paddling.

The cord sits below the can level in the recessed lower cavity, so it never interferes when inserting or removing the can. The outer sinuous form, inspired by jellyfish tentacles, provides both aesthetic flow and structural rigidity, while using minimal material.

Your design requires no support during 3D print: its curves and overhangs are self‑supporting, delivering a visually striking and functional accessory.

Print flat in your chosen PLA, layer height 0.2 mm, no supports required. Use standard slicer settings.