CR-Touch Ender 3 Pro Spacer
229 downloads · 3 years ago · My nozzle kept crashing into the bed because the touch sensor I purchased wasn't low enough to touch
My nozzle kept crashing into the bed because the touch sensor I purchased wasn't low enough to touch the bed far enough before the nozzle did.
If you have another printer, this will save you a trip to the store or another amazon purchase.
This works with the CR-Touch with an Ender 3 Pro.
FreeCAD file included if you want to mod it.
CR-Touch Ender 3 Pro Spacer
229 downloads · 3 years ago in and
CR-10 / Ender 3 Direct Drivinator - for Hero Me Gen5 fan duct
Mutant V2 Interface Plates for Popular 3D Printers
Mutant V2 Interface Plates for Popular 3D Printers
Ender 3 & 5 Direct Drive Mount for use with Hero Me Gen5 (OEM plastic and Dual Gear extruders)
CR-10S Pro X Gantry, Hot-end, and ABL sensor
PACKOUT CASE V2 – AirPods Pro Tactical Carry (3 Versions!)
#3 Nike Airpods pro 1/2 case
SpeedDrive for Hero Me Gen5 + BMG + Ender3/5/CR-10/S (Pancake compatible)
Stackable Crate (large)
“I AM YOUR FATHER” – Chibi, Vader, Care Bear, Flexi Sith Edition
Not So.. XL April showers Goose, for smaller build plates, below 300x300x300
Zeus Thunderbolt - Thor: Love and Thunder ⚡
XL April Showers Goose, for large build plates above 300x300x300mm
OYSTER MUSHROOMS ON LOG PLANTER - WITH OR WITHOUT DRAINAGE - OPTIONAL CONTAINER LID
.jpg&w=3840&q=75)
SkinFig Wolverine
Articulated Nutcracker with Swinging Arms and Stand-Up Base :: Classic Christmas Toy
HAND GRENADE WATER POT – Post-Apocalyptic Garden Gear
Fallout, Gas Can, Flower Watering Pot Mashup
Bear drawers
Thanks for this. I was gonna make my own but stumbled upon it in a reddit thread. Save me some time.