Two blades, one battle. ⚔✨

This latest design is a tribute to the most iconic weapon in sci-fi history—the lightsaber. Whether you're drawn to the light or the dark, these glowing blades represent the ultimate showdown between destiny and choice.

By day, it’s a clean and minimalist display, but when the lights go down, the energy ignites—giving off a neon glow that captures the magic of an epic duel in a galaxy far, far away.

Would you wield the green or the red? Let me know which side you’d choose! ⚡💚❤

🎨 These are the filaments I've used

• Bambu Lab Basic PLA Black
• Bambu Lab Basic PLA Glow

Print and assembly instructions

Geometric Art

• 0.20 layer height
• Wall Generator: Arachne
• Top surface pattern: Monotonic
• Infill: 15%
• Color change at layer 21 (4.20mm)

Frame

• Wall Generator: Arachne (otherwise the chances of the print-in-place latches fusing to the frame are higher)
• Infill: 15%
• To loosen the latches move them up a bit before turning them
• Use the latches to secure the artwork into the frame (TIP: add a strip of tape to the back of the artwork where the latch will hold if the latch is too loose)
• When you use the wall hook, make sure you turn the latch under the hook to the locked position before installing the wall hook. Slide the artwork under the locked latch first, position it into the frame and close all other latches

ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Companion subscription.