💰✨ Build-a-Gnome Hollow Body Add-On STL – Threaded Bottom Base ✨💰

Turn your Build-a-Gnome into a functional treasure keeper! This Hollow Body Add-On features a fully enclosed interior with a classic threaded twist-off bottom (just like traditional piggy banks). Perfect for coins, small surprises, storage, secret treasures — or even added weights for extra stability.

(Base Gnome required – this is an add-on body.) ✨ Threaded screw-on base – secure and removable ✨ Functional hollow interior for storage or added weight ✨ Perfect for coins, cash gifts, sand, pellets, or washers ✨ Prints clean – NO AMS NEEDED ✨ Designed to fit your existing Build-a-Gnome accessories

Create a gnome that’s not just adorable — but practical too! Great for:

• Coin banks
• Gift money holders
• Weighted shelf sitters
• Holiday surprise containers
• Craft fair best-sellers
• Hidden storage

Included in This Listing:

• STL files for the hollow body and threaded bottom (as shown in the photo)
• Commercial license included — no subscription or extra fees needed

Mix and match with your favorite hats and accessories to create a one-of-a-kind keepsake gnome that holds more than just charm.

🎨 Base model and accessories sold separately.

Add a little magic… and a little weight.* 💚

Important: This listing includes STL files only for the body. You must own or purchase the Build-a-Gnome Base Model to use this add-on.

https://than.gs/m/1384082

Print tolerances vary by printer. The settings used in this print were in Bambu Studio, and printed on a Bambu X1C using a 0.4 nozzle printed at 0.20mm layer height Standard print quality settings. Filament used was PLA. Plate used was Bambu Textured PEI Plate.

Adding variable height, ironing or smaller layer heights will decrease the visibility of any lines even more than what is shown in the photos.

Recommended Print Settings:

• Supports – YES
• Support Type - TREE STRONG
• Supports on Build Plate Only
• Threshold Angle - 30 degrees
• Remove Small Overhangs - NO
• Brim – YES – OUTER 10mm on BODY
• Top Z-Distance - .28
• Bottom Z-Distance - .28
• Layer Height – 0.2mm or smaller
• Nozzle Size – 0.4 or smaller
• Seam – position depends on preference and orientation on the plate
• Infill – 10 - 15%
• Wall Loops - 2+