The BB cyclone is here! AND SO are the Days of our Lives...

With a flick of the wrist, send a cascade of BB's into a suspended orbit and watch them slowly descend through the double wormhole.

The cyclone itself is a PET G print, with only a single wall, yet miraculously prints with a single tree support. It's brittle, so take care creasing, then bending the brim off, rather than tugging.

The frame strengthens and protects the cyclone and adds a distinctive timeless design with it's curvaceous spindles.

Instructions:

1. Print cyclone with glass / transparent PET G at 30-40mm/s MAX speed.
2. Fill bottom tray so that only the grooves are full of BB's, too many and it won't spin up.
3. Install 4 posts into bottom, then carefully line up the top, slowly work the joints down and carefully align top of hourglass to insert correctly before final tightening. Some filaments may need glue if posts are loose.

If you have little people or pets, definitely glue this model to secure the bb's!

If you liked this open price print, please share it!!! AND Check out our VERY popular BB and Marble fidgets!!!!

Happy printing, spooligans!