Moolly the Cow is here and ready to join your print bed!

This chunky little cow is full of charm, with a print-in-place design that wiggles and moves straight off the printer—no assembly needed.

🖨️ Print Profile

Layer Height: 0.08 - 0.2 mm (tested on 0.2 mm, but 0.16 mm or lower is recommended for best detail) Infill: 15% Gyroid Wall loops: 2 Supports: None required Scale: You can scale up freely. For smaller prints, keep scaling proportional and try lowering the Z height gradually—I tested it at 20mm Z scale and the joints still worked great!