The All-Seeing Turtle has arrived… and it’s watching EVERYTHING.

Thank you: DragonFire, NerdiStitcher, and Sam for the wonderful pictures. This one was a true test.

NOTE: The one with the 5 eyes will require some patience...slow down your out wall acceleration to 2000, and adjust the zhop or zlift (Prusa) to at least .4, possibly .6. Plus, you need to have a very clean bed plate and utilize a glue of your choice possibly.

I do not recommend shrinking the 5 eye. I was able to get it to fully print at around 90% but it took some decent adjustments.

The two-eyed version is much more forgiving. I still recommend adjusting your zhop or zlift, slowing acceleration on the outer wall, and making sure that your bed plate is really clean.

Painted 3MF included. Please double-check that the settings work with your printer before starting. Always begin a new project and verify your flush settings to ensure the best results.

Printing Recommendations:

Initial layer and initial fill: 25 mm/s

zhop or zlift set to .4 to .6

Layer Height: 0.16 - 0.20 mm

Walls: 3

Infill: 15%

Supports: None needed — this design prints in place!

Cooling: Let the plate cool completely before removing your print to avoid warping or damage.

Printer Acceleration: Slow down printer acceleration for smoother results.

Printing the outer walls at half speed helps create a nice, clean finish.

Looking for more designs? 🛍️ Browse the full collection in the Rebel Alicorn MMF Store

⚠️ Important – Please Read: All Rebel Alicorn Designs are protected under Copyright Law.

Your purchase grants you the right to download and print the design for personal use only. You do not have permission to: Resell, Remix, Alter, or Redistribute the digital files in any form

No design modifications are allowed. Except for keyring holes and straw holes, other changes must be approved.

Selling physical prints of any Rebel Alicorn design requires authorization. To become an authorized seller, you must join the “Merchant Tier” on Patreon, Thangs, or MMF.

⚠️ Safety Warning: These designs are not suitable for unsupervised play by children or pets. Broken or rough-played 3D prints may produce sharp edges or small parts that can pose a choking hazard. Not recommended for children under age 5.