See below the story for updates.

Once upon a time, in a quiet forest where the moonlight painted silver paths, two tiny bat sprites were born. The first was Edgar, who loved the cozy darkness of caves and the gentle rustle of leaves. He was happiest when he could snuggle close to the earth and listen to the secrets of the roots. His sister, Celeste, had wings that sparkled like the night sky. She was curious and brave, always flying high to play among the stars. Though Edgar preferred the forest floor and Celeste preferred the heavens above, they were never far apart. Together, they showed the forest that even the littlest sprites could bring both earth and sky into harmony, just by being themselves.

UPDATE: I added the STL files for Celeste and Edgar. There is a V2 of Celeste - The stars are separated into parts for a cleaner print.

Image credits: Sam (Blue), Dragonfire (light purple), Sillywabbit (orange rainbow), and Nerdistitcher (dark purple)

Painted 3MF included. Please double-check that the settings work with your printer before starting. Always begin a new project and verify your flush settings to ensure the best results.

I do not upload the STL - If you need one you can easily savie it by going to File --> Export as one STL

This print has been tested from 50% to 200%

Printing Recommendations: Initial layer and initial fill: 25 mm/s Layer Height: 0.16 - 0.20 mm Walls: 3 Infill: 15% Supports: None needed — this design prints in place! Cooling: Let the plate cool completely before removing your print to avoid warping or damage. Printer Acceleration: Slow down printer acceleration for smoother results. Printing the outer walls at half speed helps create a nice, clean finish.

Looking for more designs? 🛍️ Browse the full collection in the Rebel Alicorn MMF Store

⚠️ Important – Please Read: All Rebel Alicorn Designs are protected under Copyright Law.

Your purchase grants you the right to download and print the design for personal use only. You do not have permission to: Resell, Remix, Alter, or Redistribute the digital files in any form

No design modifications are allowed. Except for keyring holes and straw holes, other changes must be approved.

Selling physical prints of any Rebel Alicorn design requires authorization. To become an authorized seller, you must join the “Merchant Tier” on Patreon, Thangs, or MMF.

⚠️ Safety Warning: These designs are not suitable for unsupervised play by children or pets. Broken or rough-played 3D prints may produce sharp edges or small parts that can pose a choking hazard. Not recommended for children under age 5.