No Supports, Multicolor Coin Subscribe To the Mimetics 3D Commercial Tier on Thangs. for rights to sell prints of your cool new friend.

I got slightly distracted while making dragons, and decided to chase the rabbit a bit.

This Grinning Emoji Coin is the result :D

This coin is an easy, surprisingly satisfying multicolor print that you can do either with a multicolor system OR manual layer swaps.

It prints quickly and you can fit a WHOLE LOT on a single build plate for a fast, satisfying print.

Instructions For Bambu Users: Use attached 3MF and choose between which of the 2 plates works best for you. The left one is multicolor, while the right is layerswaps. (With only a few seconds difference between them.

For other slicers/machines: Print at 0.2 layer height and swap at the following layers.

Start: White Filament Swap at Layer 5: Yellow filament Swap at Layer 15: Black Filament

Other Models: FD3D Mimic Chest - This VERY friendly Mimic chest is a collaboration with Felicia Day (FD3D). Check it out on her profile! Baby Amethyst Dragon Leo Zodiac Dragon

Dice Guardian - Articulated Dragon