Foot Fish // Foot File Callus Remover
FREE for a LIMITED TIME
Keep your soles silky smooth with these Foot Fish! Use this rasp set during a warm shower to scrape off dead skin and maintain a healthy sole. 3 different scales allow you to use the right intensity for your feet, to gently keep them soft.
The Rasp 'scales' snap into the Fish body so you can replace them when necessary.
Printing Guideline
Print using a filament that can withstand the temperature of a warm shower. PETG, ABS, and ASA are all suitable options. The Rasp parts print standing up and have a small footprint, so a big brim is helpful. Otherwise, your default settings at 0.16mm layer height should work fine.
-10mm brim -4 perimeters/shells































These are the best tools I have used for my feet 👍🏻👍🏻. One for between the toes would complete the set.
As a paraplegic I suffer from poor circulation to my legs, especially my feet. As a result I get a lot of dead skin on the sole and sides. I have tried so many options from the chemist but they only half worked and most don’t allow me to use them in the shower when my kin is the softest. I printed these with PETG and they work AMAZING. My feet have never been so smooth in my life. And I am not exaggerating. Iv’e been disabled my whole life. Thank you very much for these ♥️♥️♥️
That's fantastic to hear! I'm so glad you found these useful :)