He'll shimmy down the chimney and eat your face. He's Santa, he's a zombie - he's Zombie Santa. Don't ask what happened to the reindeer, just don't go there...

This is a pair of 100mm diameter leather stamps.

I print all leather stamps with 4 walls at 50% triangular infill at 10% moisture. Anything less can result in failure of the wall structures.

A rigid filament is recommended, such as PLA+, CF PLA etc. Cheap PLA doesn't work well. If that's all you have, add an extra wall line for increased rigidity. After printing I use a small plastic brush to remove any small stringing.

Stamps can be used for other fabrics and materials. I recommend testing a small piece before stamping any expensive materials. I dampen leather before stamping for a better impression.

Dry your filament, eat your vegetables, don't do drugs.