Important Note!

Support must be used on the outer edges. Therefore, please enable the support option when printing the outer parts.

There are products that are not used often but are absolutely necessary. That is SD card. If you mix it with other small products, it is hard to find it, so it would be nice if you keep it separately.

This SD card holder has added fun to such applications. This product, which takes the form of a toaster, offers a little fun by putting an SD card in place of paper.

The product is divided into two pieces, one on the outside and one on the inside, and is assembled after print.

The assembly method is to insert the inner piece by pushing it from the back of the outer piece. It can be a bit tight, so you have to put it in harder.

But after assembly, it is a bit loose. Therefore, the adhesive will stick to the bottom of the outer piece and be fixed in front of it.

It is also good as an interior accessory by collecting several pieces in various colors.

XYZ - 46 x 46 x 24mm

Design by GOODesign