Download here now the new hi flexi rainbow fish

Simple to build & print - All you need is a small amount of superglue or 3D gloop & can be built easily in under 10 minutes

Can be printed in multi-color using any 3D printer - The head, eyes and body sections are printed separately and the eyes can be printed in 2 colors by pausing the print and swapping colors.

Print settings -

Supports enabled on the head section only (tree recommended)

No support or brim anywhere else

Z-hop enabled to help bed adhesion

If using the connectors to assist with gluing the body recommend printing very slowly (10mm/s) But these are non essential

Build instructions -

Once printed and supports are removed from the head glue the 2 eyes in the sockets on the head

You can carefully insert the connectors into their small slots on the fins if you choose to use them

If you decide to not use the connectors, simply apply glue to the fins on 1 side and align with the opposite side of the body and glue - it's is recommended to glue each one individually

It's not essential to glue each individual link - just a few on the outside links where the holes for the connectors are

Carefully glue the large ball socket holder at the opposite end of the tail so it's aligned perfectly then insert the head into this socket

Assembly time approximately 5 - 10 minutes

Any questions and I'll be sure to help as best as possible - enjoy