Cute and Wiggly Polar Bear tasting an Ice Cream from the North🍧🐻‍❄️! They took it from this Ice Cream Cart🩷🩵!

You will get:

🐻‍❄️ 4 STL files 🐻‍❄️ 1 Pre-Painted 3MF file

Here come the Bear snap-fit Head, Middle, and Bottom parts. The Head also comes as a keychain.

I’ve also prepared a pre-colored 3MF file in case you run into any issues with painting.

⚙️Printing⚙️

Support-free design, User-Friendly Snap-Fit assembly once printed.

The Bear scaling was tested down to 80%:

• 0.16 mm Layer Height

• infill 15%, Gyroid

• 2 wall loops

• Basic PLA

For the best results, I recommend a 0.16 mm layer height.

When using softer PLA (like PolyTerra), make sure not to scale the model down too much, as the smaller joint parts may break or deform more easily.

Customize it your way! You can move, scale, or remove parts like the pupils and claws. Just click on the Bear model in your Slicer Software, use Split Into Parts, then Alt-click the part you’d like to tweak.

All printing tips and suggestions can be found in the PDF file after purchase! 🩷🩵📃

Get a Commercial License, Monthly Deals, Bonuses, and a Welcome Pack with Exclusives:

Patreon

Happy to see you and your prints on my Socials:

Instagram TikTok

😊 Happy Printing!