Lightweight Glider for Indoor and Outdoor Fun

Gliding properties may vary with your filament.

Preparations

Bend wings slightly upwards Bend tail to a V shaped stabilizer Bend tail slightly upwards directly behind the wings.

Launch

Hand launch Grip between wings and tail and throw gently

Gummi band launch Hold the band as you like Place sling on edge on the bottom Shoot

Catapult start Place plane with edge directly on the sling Shoot

Mini crossbow start Perfectly fitting crossbow:

Put in barrel part of the crossbow, align the rear end of the plane's body with the nylon thread, hold level, let fly.

3D Print Settings

Layer height: 0.1mm (works best) - 0.2mm Infill: 100% Outer Lines: Min 3 Placement: Glider is rotated 45° in z-axis so that the infill of the first layer goes along the wings. This gives some rigidity when bending the wings and stabilizers.