It has been long requested that I make a handle type drawer pull instead of a single hole knob type pull. Today is that day. This design is print in place and does not need supports. It is sized at 76MM from center to center holes for the screws.

Important : You need to add a pause at layer 31 (if printing at .2mm layer height.) this is the layer before the cavity for the nut fills in. at this pause you need to insert an 8-32 nut into the print on both sides. If you skip this, your 8-32 screws will have nothing to screw into when your print is done.That said, you will need 8-32 machine screws and nuts for this project, I used these: Click here

I hope you enjoy this design!

-Billy