for todays design, I made this orc head drawer pull! I included two versions, a pause, and a no pause version. For the no pause version, simply just print it and when its done, you can insert an 8-32 nut into the cut out slot so that you can fasten it with an 8-32 machine screw. for the pause version you will need to add a pause at layer 35 if printing at .2 layer height which is the topmost layer before the cavity for the nut seals up. during the pause, insert an 8-32 nut then resume the print.

I used these 8-32 nuts and screws: click here

no supports are needed for this print. ENJOY! -Billy