Here is Phone swivel desk mount adjustable, This awesome design lets you attach your phone to your desk or table and position your phone in any direction vertical or horizontal, The design is designed to be tight enough to hold your phone in position with gravity but not straight out, can also Be hung upside down. To assemble the design Screw the Threaded arm screw into the desk clamp then Clip the round nut onto the end of the threaded screw, I recommend Heating the end of the nut with a heat gun to allow easier connection, as the nuts are designed to be as tight as possible, also use this set with the swizle arm joints. Next Select the phone Body size, the size's are based on the first Screw setting in the body, each body has three adjustable screws 15mm apart. Next Place the Screw lock into the back of the body and tighten to lock the phone in Place, Finally attach the to attach the swivel arm Joints onto the phone body and desk clamp using previous set,

Print settings supports needed for the Desk Clamp, Use Supports normal Overhang angle 20%, no Supports needed for the threaded nuts or clamps just print them flat head down, Print speed 100mms, Infill 20%, Nozzle Size 0.4mm, Layer Height 0.2mm,