4-17-26...print! I've had requests for more sports themed layered fidgets - so here is a football 🏈 No AMS required.

Dimensions: 3 in. x 1 7/8 in. x 1 1/3 in.

3D PRINTING SETTINGS: Layer Height 0.2mm PLA works great 15% Infill No supports needed

Note: For best adhesion, make sure the print bed is clean before printing

I've included a 3mf print project with the following print plates: Print Plate #1 (Football Layered Fidget_body): one color Print Plate #2 (laces and stripes): one color

To assemble: Push the laces into the corresponding area on the football layered fidget. Next, use a small amount of super glue to adhere the stripes onto both ends of the football.

You could scale up or down on this but I would caution about scaling down too much because that will result in thinner the walls and tighten the spaces between the layers resulting in a less satisfying fidget.

Have fun printing! Erin