The dead spine characters series always seem to work, So today I present you Rudolph The Dead Reindeer! He is entirely multi-part, Except for the teeth :( So you'll either have to use your multicolor system or do some quick hand painting on this part. He also has a brain/no brain version you can pick from.

Printing:

• Head & Antlers require supports - Use organic/tree supports
• Use a brim for the Bell, Antlers & Spine (not mandatory but I did)

Assembly:

• The eyes snap in with some force and the arrow on the bottom of each eye should be facing the nose
• Once you push the eyes in it will be very difficult to take them out, so make sure you aligned them correctly with the arrows!
• Push the bell into the collar and place the collar on top of the body (use glue on collar)
• Antlers, Nose, Pupils and Brain might need some glue
• Push spine into the head with flat area facing backwards

You can scale up/down as you want just watch the spine for fusion if you're going for an extremely small scale.

Note: The hat was a last minute addition and it's not perfect! I'll be adding a redesigned and improved hat in the next few days so if you want you can wait for the improved one.