Goku God Mode - Printing Instructions Included

All the necessary printing instructions are included in the file. If you have any questions, feel free to DM me!

Assembly As shown in the photos above but also numbered on the STL Files

You will need a 1mm thick glass layer or any transparent material of your choice. Also, make sure to have a strip light of your choice for the lighting.

For Commercial Use & More: https://www.patreon.com/c/ACSPARK3D

Enjoy showcasing your Goku God Mode lightbox!

Note to always put the transparent layer last

LightBox Frame Settings: Layer Height: 0.2 Walls: 2 Bottom: 2 (Or 3 to hide infill lines) Top: 2 15% Infill

LightBox Back Plate Settings: Layer Height: 0.2 Walls: 2 Bottom: 3 Top: 3 10% Infill

LightBox Transparent Layer: Layer Height: 0.2 Walls: 2 Bottom: 2 Top: 2 1% Infill

Design Layer Settings: Layer Height: 0.2 2 Walls 2 Top/Bottom 3% Infill No supports.