This is the complete AMPro 20mm vertical offset front double wishbone set. One order has every single part attached by a small sprue or pin. This comes in SLS Nylon (shown in the video, painted) or MJF which is stronger. We recommend no more than a stock motor be used. Left and right arms can be purchased individually. Be careful with the cosmetic shock mount as it is very weak in comparison to the structural one.

This will not work with the Grasshopper body without significant modifications.

See video before your purchase.

Hardware List:

1. 4x 30mm Screw Pins
2. 2x 4.8mm Ball Studs, 6mm stud
3. 2x 4.8mm Ball Studs, 8-10mm stud
4. 6x M3 washers, no more than 0.5mm thick
5. 2x M3 Nut (not nylon locking nut)
6. 4x 4.8mm Ball Cups
7. M3 threaded rod for upper link (length needed is less 50mm, two 20 mm screws can be cut down for this too. Actual length is not known. Dependent on ball cups length)
8. 2x M3x18mm screws
9. 2x M3 nuts
10. 4x 4mm x 6mm brass tubes
11. 2x 3mm x 12mm screws
12. 2x M3 self tapping screws, 8mm long

Other Components

1. 60mm eye to eye shock, standard bore

Special Tools Needed:

1. 3mm-3.1mm drill bit. Do not use a 1/8" bit

Note: In some cases, original Hornet tie rods are slightly too short and need either updated turn buckles installed. This is not an issue with Re-release hornets as those tie rods are much longer.