Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3909319.
All four turn signals on my 2002 Kawasaki VN1500 Vulcan Classic Fi were in a sorry state - you can see one of them in the photos. I know from previous experience that replacements for these are in the $50 a piece price range. Believe me. I'll do some rigging to save $200!
For some reason, you can't even buy just the stems themselves, even though the turn signals are designed to be disassembled into it's individual components. That made designing replacements a lot easier. I thought I was going to have to design a complete assembly, but once I took one apart, I found that wasn't the case.
These are designed specifically for the Vulcan, but I am sure that these will fit a wide variety of bikes. The stems on the front signals are 50mm long, while the rear stems are 80mm long. In my design, the threaded pipe not only serves as a pass-through for the wires, but it also aids in adding stability to the stem.
To assemble these, you will need, from the original turn signal:
- the lamp socket (and obviously the lamp itself)
- the rubber grommet on the wires
- the clip
- the reflector
- the lens (including the gasket and the screws)
- the head
You will also need to purchase:
- 1/8" IP brass plated lamp nipple - you'll need 65mm for each stem
- 1/8" IP brass nut for each stem
- 3/16" stainless steel washer for each stem
NOTE Due to either a Thingiverse bug or (more likely) shadowbanning, my models no longer show up under the [Newest] listings. If you want to see more of my models, please be sure to 'follow' me. If you print this, it would really help if you'd post a 'make' so that others could find this model.