Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4715590.
Since thingiverse can't seem to get their shit together and actually show the models that we upload under our profiles or in searches, this is the only way to get some models shown. If you want the files for the real model, you can click on the model from which this was "remixed."
Fix Your Damned Site, Thingiverse and I wouldn't have to effect workarounds to get some semblance of functionality around here!
Just for the Search Scraper [which is always broken, too]:
Mermaid Corbels - Repaired by RebelTaz
I loved the look of these Mermaid Corbels (I didn't even know what a "corbel" was before I saw these!) uploaded by @darkside501st but when I went to print them, all three threw up errors in Cura, with the left being the worst. The left model was turned completely inside out! I imported these into blender, cleaned them up the best I could, and then let netfabb do the rest. I would have preferred to get these down to a single shell, but ... you have to balance time and effort with results.
For the best quality, print these upside down with supports enabled. I prefer Tree Supports in Cura. They are easier to remove and leave fewer scars.
I wanted to use these on an 8" shelf I put up so I added a stretched version of each that extends the upper ledge by 54.5mm. Then I was able to scale it up in my slicer as large as I could go - about 6-1/2" long. I reckon I'll use either Gorilla Glue or Liquid Nails to attach them.