DT

1.25" Pool Hose Coupler

by
rebeltaz
Follow
Follow
Remix Model
1.25" Pool Hose Coupler 3d model
1.25" Pool Hose Coupler 3d model
2D
3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms. 

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2944664.

When you need a coupler to connect two 1¼" pool hoses together on a weekend out in the sticks and every hardware store is closed.... you print one :) This quick little print only takes about an hour with a 0.3mm layer height and a 60mm/sec print speed. This is a snug fit and since I'm just using this on the waste side, I didn't bother with clamps, but if you are using it on either the inlet or output of the pump, I'd recommend clamps around the hoses.


Another Sketchup Model - Debunking the Myth that Sketchup is Useless in 3D Printing


1 Likes9 DownloadsApril 26, 2022


1 Likes9 DownloadsApril 26, 2022
This model is restricted by licensing terms.