For use with Kinnarps cabinets. Pop off the beige plastic plugs on top of the cabinet and replace with the hook. This hook v3 is superior to the previous v2 model found on my Thingiverse-account, it is stronger and easier to print and works better over all.

Print the Kinnarps v3 hook without support, it already has a break away support built in the model. I use a Wanhao i3 Plus printer with a 0,6mm nozzle and 0,24 mm layer height. But a 0,4 mm nozzle with 0,2 mm layer height works just as well, perhaps even better.

The built in break away support skips a 0,24 mm layer before the overhang is printed. I can snap it off with my fingers when the model has cooled. Use two or three walls depending on your nozzle-size, and 50% cubic infill. That should give you a ready to go working hook without any after processing.