This is a general-purpose shelf suitable for holding things such as keys, coins, phone, etcetera. The shelf is approximately W140mm x D70mm.

This accessory is part of a system of inter-compatible mounts and interchangeable accessories. The available mounts are available here… https://thangs.com/mythangs/collections/131287

Print Settings

For the best results, I recommend the following:

Material: PLA or PETG Nozzle: 0.4mm Layer Height: 0.2mm Line Width: 0.4mm Wall Count: 4 (1.6mm) Top and Bottom Layer Count: 5 Detect Thin Walls: ON Infill: minimum 40% (Cubic) Ironing: Not required Brim: No Support: No

For additional information and instructions, please check out my blog site… https://www.logicalplanet.com/collections/wallplatemate/

If you have not already, also check out my Wall Plate collection here…. https://thangs.com/mythangs/collections/131283