This large remote control holder measures D60mm by W105mm inside and can accommodate one or more moveable walls to section off the remotes from one another.

This accessory is part of a system of inter-compatible mounts and interchangeable accessories. The available mounts are available here… https://thangs.com/mythangs/collections/131287

Print Settings

For the best results, I recommend the following:

Material: PLA or PETG Nozzle: 0.4mm Layer Height: 0.2mm Line Width: 0.4mm Wall Count: 4 (1.6mm) Top and Bottom Layer Count: 5 Detect Thin Walls: ON Infill: minimum 40% (Cubic) Ironing: Not required Brim: No Support: No

For additional information and instructions, please check out my blog site… https://www.logicalplanet.com/collections/wallplatemate/

If you have not already, also check out my Wall Plate collection here…. https://thangs.com/mythangs/collections/131283