Bed Level Correction Assistant

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4105026.

#Make bed level correction easier and quicker! ##Optimized for Original Prusa printers. ##(Mostly)Parametric Fusion 360 design file included

###Procedure: (Assuming you cleared EEPROM and have to start over)

• Run XYZ Calibration
• Meanwhile slice all 4 STLs with your general settings
• Run First Layer Calibration to achieve basic adhesion
• Print Live Z.stl, observe bottom face and adjust Live Z, repeat until desirable bottom surface finish is achieved
• Repeat with Front_Back.stl, please note L shaped indicator points to the front of the machine, adjust Bed Level Correction.
• Repeat with Left_Right.stl, this time indicator is on the left side and is also pointing to the front.
• Finally print Whole Bed.stl to confirm and compare all bottom finish of all squares.