This model is for a clutch that requires minimal assembly. There is a pause command inserted at layer 2 to add the fabric, and another pause at layer 13 to add 10 magnets that are 10mm x 2mm (5 on the top bar and 5 on the bottom bar) for the closure. Insert these magnets in the same orientation in all holes. There are holes at the top of the clutch for jump rings to attach your strap of choice. Line the inside with a fabric of your choosing, I like using a little thicker fabric and a permanent fabric glue. You can also use E6000. Fold the sides over, gluing them together, one at a time.
This is intended to be printed face down on a build sheet that offers some effect, but the textured effect can be just as cool. I like using tri color silk PLA with these, with the bottom layer as octogram spiral - Change the bottom layer pattern to get a different effect! My favorites are octagram spiral and archimidean chords
There is an additional version if you'd prefer to use snap fasteners (size 15) instead of superglue.