Printing Difficulty 6/10 due to supports and parts cooling

for best settings:

• Ensure you have proper retraction and bed level settings
• Set model 1-2mm above build plate
• 0.20mm layer heights
• Enable supports, from bed only 10% support wall density 90-95% support top/bottom density

Speed can be anything from 45mm/s to 100mm/s depending on your machines settings (mine was done at 150mm/s with heavy upgrades) Parts cooling is required in a few areas and would recommend a minimum layer print time of 10s or more if you dont have adequate cooling Supports should if calibrated properly peel right off with only a little effort applied