By confirming your subscription, you allow Thangs to charge your card for this payment and future payments in accordance with their terms. You can always cancel your subscription.
Zeus and the Giants (Stone Carving) - Hueforge Print
This was printed with a 0.2 nozzle, which produces 0.04mm layers a little nicer. It is possible with a 0.4 nozzle, though you will need to have calibrated your printer and filaments very carefully.
You can however, still print this with a 0.4 nozzle and change the layer height to 0.08mm, by just adjusting the .hfp file.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
Filaments Used:
PLA Siddament Black Transmission Distance: 0.2
PLA+ Sunlu Coffee Transmission Distance: 3
PLA Sunlu Beige Transmission Distance: 8.2
PLA META Sunlu White Transmission Distance: 9.6
Swap Instructions:
Start with Black
At layer #24 (1.08mm) swap to Coffee
At layer #28 (1.24mm) swap to Beige
At layer #43 (1.84mm) swap to White for the rest.
Your filament settings and mine may differ in TD, so best to adjust yours according to your known TD filaments.
