2D3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms.
View license.
0 Likes0 DownloadsJune 27, 2024
This model is restricted by licensing terms.
View license.
This prints in place in one piece without any needed supports. Just take it off your print bed, insert a JoyCon and you're ready to play!
No specific print settings are needed, just adjust the infill percentage to make the controller as dense as you want. This will accommodate both the left and right JoyCon.
v1 uses a fillet on the bottom surface which may not print as expected v2 uses a chamfer on the bottom surface and is the recommended version
Categories:
0 Likes0 DownloadsJune 27, 2024
This model is restricted by licensing terms.
View license.
0 Likes0 DownloadsJune 27, 2024
This model is restricted by licensing terms.
View license.