Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4920704.
I had a spare all-metal hotend from my CR-6 SE, so fitted it to my Flsun Q5.
Alterations from the metal cage made to cater for the CR-6 SE hotend mount design. I recommend printing in PETG. The heatsink remains remarkably cool (tested heat block up to 260C) so there shouldn't be any warping. PETG gives the flexibility to move the cage and reinsert screws as needed to fit.
You will need to completely dismantle the existing Q5 hotend to assemble this. The only extra hardware I used were some screws:
2 x M3x16 ,m flat head screws to attach to the side of the cage 2 x M3x12 button screws to attach to the top of the cage 2 x M3x8 button screws to attach to the bottom of the cage through the effector plate
This should fit both the Prima 3D hotend as well as the Micro Swiss hotend.
Everything else fitted back into place as normal. I also fitted the heat block and sock that came with the hotend kit. I did not need to replace the part cooling duct.
Don't forget to PID tune, Delta level and Z Offset calibration for the new parts.
Tested successfully with PLA, PLA+, PETG and ABS.