Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4921536.
2021-08-03 - Improved the bottom part
Designed for the CR-6 SE, this helps guide the filament from a top mounted spool holder down to the runout sensor.
The bottom part fits over the filament runout sensor. The top part snaps onto the top left of the gantry structure.
PLA is fine as there's no stress on the parts.
Additional hardware:
2 x PC4-M6 pneumatic fittings, one for each part.
Be careful to have your x axis at bed level before cutting tubing to fit as it will have to extend that far as the gantry moves.
It's best not to use clips on either pneumatic fitting.
Because of the extra length of tubing needed, it does make it trickier to load the filament, but you can always pop out the tube by the runout sensor and push the filament through and then reattach.