The Modular Keychain Tower is a stackable display made to hold your favorite keychains, charms, and tiny trinkets all in one place 🥹 Each layer slots together so you can build your tower up (or keep it smol!) depending on how many goodies you have. There is one piece that was built for a specific part of the tower, so it may fit tighter, but still retains modularity.

Fill it with keychains and minis!!

⚠️ Experimental Model Disclaimer ⚠️
This design is considered experimental and may require extra patience or tweaking to print and assemble properly. While I've done my best to test and refine it, your results may vary depending on your printer, filament, and settings. This model will not be updated, as it was a personal for fun project for a quick display I created a while back. In the future, I may make a more complete/refined rendition.

🧪 Things to keep in mind:

🟣 The taller you make your tower, the wobblier it will be if you do not glue it down. You can either keep it unglued for portability/modularity, or you can choose to glue it down for stability.

🟣 You can cut off the top of the keychain hook to make it shorter in your slicer if your keychain loop doesn't fit over it. I made it a little taller so my ball chains don't slide off.

🟣 Please make sure to use enough infill/walls so the insertable shafts do not break.

Recommended Print Settings

• Layer Height: 0.16
• Infill: 15%
• Supports: Not usually needed
• Filament: Matte or regular PLA
• Adaptive Layers recommended for smoother effect, but I did not use them in my prints~

Grab them on MakerWorld !!

With pawsitivity,
Mouse ☕🌙