[Bonus Exclusive] Treasure Chest Storage Box

Hii friends!! I'm almost done with a super cute new release that I think you will all love 👀, but this is a li'l bonus goodie (in addition to everything else I have planned) for the month that I thought would look cute with Emmy!! A simple little treasure chest storage box- but it also comes with some printable gold if you don't have your own treasure to put inside!! I think it works well for dice :]

Emmy Dragon is not included in this release & just a fancy shmancy model posing for the camera, but you can get her in my previous post (or if you're looking at this from the future, on Cults3D or MMF).

Assembly/Special Print Instructions:

✨ Place & glue the three aligners into one side of the chest, and add glue into the indents on the other side. Glue both sides of the top of the chest together. It is separated so you do not need supports to print it. 😊✨💖
✨ The top of the chest needs to be printed with adaptive layer height for maximum layer smoothness- or the layers will be more visible as the chest shape flattens out more at the top.
✨ The square insert size can vary depending on your printer's tolerance. If the square inserts are too tight, you can adjust the size down by 1-2%. If they are too loose, you can adjust them up by 1-2%.

Recommended Print Settings:

• Layer Height: .16
• Infill: 15%
• Supports: Not needed
• Adaptive Layer Height recommended (but will slow print down)
• Pro Tip: If the first layers struggle to stick, try slowing down your first layers or increasing the bed temp slightly.

Please be warned that these models are not recommended to be printed for young children, or anyone at risk of a choking hazard. There are small parts that can be broken off if roughly handled. Print at your own risk!