Printed the "pre-supported" version. It wasn't hard to get the fidget out, but a little did snap off in the support. Not very noticeable. I defintely could've done a more careful job getting it out. I did sand the edges a bit, because i didnt like how that part felt. Overall a great model. ~2 hr 20 min to print for me.
Great design. I love the way it prints in place and then you can squeeze and squash it. No supports needed if you print the pre supported version. It took about 3 hours on my Anycubic Kobra 3 Combo.
Discussions — Squish Ball Print in Place Fidget Toy
What is the easiest way to remove the support on the bottom?
Just break it off. There is no special way to this.
Very cool! I love these and want to print many mor
I love this but can get a nice print supported or not supported bottom missed up. any ideas you could give me?
the pre supported needs supports
my printer refused to let me print this, i have a flash forge AD5X, does anyone know how i might be able to get it to work?
mine took 25 hours no joke
hjhjknjn;jin
will this work on the flash forge m5 adverture?
No idea. Just try. It's just 1/11 of a spool of filament.
it works
did it work?