These folded parts absolutely SUCK in ABS/ASA - they just break immediately at the seams. They're fine in PETG, and still sorta crappy but usable in PLA.
I would also really like a non-folded version of this, even if I'm giving up a little strength in print orientation.
I just printed several of this new flush snap with some friction hooks and its not working anymore. There is no friction at all! There is just too big gap between the snap and the hook. Please check it and update the model.
These have a really small amount of surface area that touch the build plate. I had many failed prints with these due to bed adhesion issues on my BambuLab P1S.
What finally worked for me was printing with a single layer raft using Support for PLA/PETG as a raft material (usually only recommended as an interface material, but worked perfectly in this case).
If anyone is interested here is my remix version to make a solid version of the snap that works well with the brackets and T-Bolts.
https://thangs.com/mythangs/file/1511143
Is there a version of this that isn't split? I find it's not staying on (using the T bolt) because it just bends apart leaving the T-bolt still screwed into the part.
Discussions — Heavy Weight-Bearing Hook Snap
These indeed do not work for Bolt-locked shelves. The Locking T-Bolts (https://thangs.com/designer/Multiboard/3d-model/Locking%20T-Bolt-1310062) just slip out of them because of the hinged design.
This is true I have been banging my head for hours trying to get this split version to stay in place.
Yup same, could not for the life of me get these on with a bolt locking shelf.
same as everyone else. I super glued them together and that worked but still, would love a non-split version.
These folded parts absolutely SUCK in ABS/ASA - they just break immediately at the seams. They're fine in PETG, and still sorta crappy but usable in PLA.
I would also really like a non-folded version of this, even if I'm giving up a little strength in print orientation.
I just printed several of this new flush snap with some friction hooks and its not working anymore. There is no friction at all! There is just too big gap between the snap and the hook. Please check it and update the model.
same
These are difficult to install.
These have a really small amount of surface area that touch the build plate. I had many failed prints with these due to bed adhesion issues on my BambuLab P1S.
What finally worked for me was printing with a single layer raft using Support for PLA/PETG as a raft material (usually only recommended as an interface material, but worked perfectly in this case).
If anyone is interested here is my remix version to make a solid version of the snap that works well with the brackets and T-Bolts. https://thangs.com/mythangs/file/1511143
Any resolution to this? I am having the same problem when using t he T bolt they just spread apart and fall off.
Weak point for me was the bend; this caused a shelf to fail. Trying to find a stronger way to hang for these.
Is there a version of this that isn't split? I find it's not staying on (using the T bolt) because it just bends apart leaving the T-bolt still screwed into the part.
Same for me!!
Installed these the wrong way around - Is there any way to remove them?
You can use the offset snap removal tool to pull them out at an angle. I got a few of these stuck as well and that did the trick.