Check Out the New Emerald Dragon
Thank you for all of your support with last week's model, the Pearl Dragon. I was delightfully surprised to see both variations at the top of the Thangs Trending page over the past few days.
Hopefully you like the Emerald Dragon just as much :)
Both the Pearl Dragon and the Emerald Dragon use a new version of the Snap-Flex joint that should be more durable and minimizes the need for multiple tolerances.
If the locked Snap-Flex joints are too tight at first, I suggest snapping them all together and then flexing the model side-to-side a few times to loosen up the joints a bit. Because of some changes I made to the joint's geometry, this method should work better than on the previous Snap-Flex joints.
As always, I'm really eager to hear any thoughts or suggestions you have about these models. Please feel free to reach out and let me know what you think. Thanks! :)
Seeya Around!
~Tom (Mimetics3D)