Articulated Dragon - Pearl Dragon, Style #2 - Snap-Flex Fidget Toy

Check out the latest Articulated Dragon model: The Emerald Dragon Check out Pearl Dragon Style #1 for an alternate eye design

Print-In-Place, No Supports, Articulating Fidget Toy Subscribe To the Mimetics 3D Commercial Tier on Thangs. for rights to sell prints of your cool new friend.

Snap-Flex Collection: This articulated fidget toy integrates the Mimetics 3D "Snap-Flex" joint. This allows the model to both move smoothly, mimicking the fluid motion of living creatures, AND stabilize in a firm pose, providing a premium fidgeting experience.

Each SNAP will resonate as a symphony of satisfaction to your ears, confirming your masterful manipulations.

Snap-Flex Instructions: To Lock: Push Body Segments together To Unlock: Pull Body Segments Apart

This model is for personal use only. If you're interested in selling physical prints of this model, please subscribe to the Mimetics 3D Commercial Tier on Thangs.

Print Settings: 0.2mm Layer Height 3 Wall Loops 3 Top Shell Layers Good Bed Adhesion Required - Consider using glue stick or a brim

Suggested Material: PLA or PLA+ Note: Silk PLA is too weak to hold up to repeated use of the Snap-Flex joint. Use silks at your own risk

No Supports, Print-In-Place at 100% scale Printing any smaller may disable the Snap-Flex joint.

Printing larger than 100% will make the snap louder AND harder to pop, so be sure to do a shorter test print to make sure it's not TOO hard to snap into place.

These tolerances are TIGHT and you'll likely have to snap each segment a few times before it's loose enough to snap/unsnap easily. I recommend you use regular PLA or PLA+. ABS might be even better, but I haven't tried it yet.

If you print this in resin, please let me know how it turns out. I imagine you would need a more flexible/less stiff resin for it to work appropriately.