MiniDrake V9 – Recommended Print Settings

Layer Height: 0.1 for finer detail – 0.2 mm for faster print Wall Line Count: (MIN) 4 for strength Infill: 15 - 20%
Top Layers: 5
Bottom Layers: 4

Notes

• No supports required
• No brim needed
• A raft isn’t necessary unless your build surface is unreliable

MiniDrake V9 Keychain – Recommended Print Settings

Layer Height: 0.12–0.2 mm
Wall Line Count: (MIN) 4 for strength Infill: 20–30% (for extra durability on the ring loop)
Top Layers: 4
Bottom Layers: 4

Notes

• Prints cleanly without supports
• Brim optional if your printer struggles with small contact patches
• Raft only recommended for warped or worn build plates