Planned maintenance is currently underway. Some operations on Thangs might be interrupted.
Looking to gain more exposure and add an additional revenue stream?
people complaining about free files. hahahaha
Unfortunately, this is the way.
Layer Height really 9 mm ??
Why is it tagged sports 💀
how will you see through it
Is it 501st approvable?
I think its amazing well done
dimentions?
Whoa you're back! I love your gear phone stand btw, one of my fav stands / prints :)
Where is this gear phone stand?
Ok
what or where is the license for these builds
🤓
Am I blind or is there no license attached? I would like to know if I can remix it, or if that would be going to far.
any way you can seperate the ear pieces and the vent?
amazing
cura will work with it just unzip the files
its sad :(
cura doesnt let me use this file >:(
Cura doesn't accept certain types of files, i usually have to go through a time-consuming process just to print one model
I sliced it up into the front and back halves of the dome and the brow band is printing as a different piece than the dome itself. It looks like I can just weld the inside tho. Just a warning for noobs like myself
why when i try to put the stl file of the helmet in cura does it not exept it
maybe your printer is too small
Discussions — Mandalorian Helmet
people complaining about free files. hahahaha
Unfortunately, this is the way.
Layer Height really 9 mm ??
Why is it tagged sports 💀
how will you see through it
Is it 501st approvable?
I think its amazing well done
dimentions?
Whoa you're back! I love your gear phone stand btw, one of my fav stands / prints :)
Where is this gear phone stand?
Ok
what or where is the license for these builds
🤓
Am I blind or is there no license attached? I would like to know if I can remix it, or if that would be going to far.
any way you can seperate the ear pieces and the vent?
amazing
cura will work with it just unzip the files
its sad :(
cura doesnt let me use this file >:(
Cura doesn't accept certain types of files, i usually have to go through a time-consuming process just to print one model
I sliced it up into the front and back halves of the dome and the brow band is printing as a different piece than the dome itself. It looks like I can just weld the inside tho. Just a warning for noobs like myself
why when i try to put the stl file of the helmet in cura does it not exept it
maybe your printer is too small