This model is restricted by licensing terms.
View license.
71 Likes195 DownloadsAugust 4, 2023
This model is restricted by licensing terms.
View license.
What a spooky Springo!
Print at .15mm layer height and separate spring manually after printing. No supports required!
100% infill is recommended. Results vary by slicer, but basically make sure the layers above and below the small Springo gaps are printing solid (Simplify3D recognizes these as top and bottom layers so you can use a lower infill, but Cura won't recognize the layers as top/bottom, and therefor prints infill instead of solid).
You can use a glow-in-the-dark filament like Polymaker Blue Glow PLA for a cool effect!
This is a remix of the "Low Poly Skull" by slavikk on Thingiverse
Category:
71 Likes195 DownloadsAugust 4, 2023
1This model is restricted by licensing terms.
View license.
71 Likes195 DownloadsAugust 4, 2023
This model is restricted by licensing terms.
View license.