This is a spinning organizer. It was made at our daughters request to have extra storage for all of her makeup. It prints in two pieces, so there is no need for supports!

Print settings: .2 layer height 10-15% infill 3 walls no supports no raft/brim unless you have adhesion issues

This file is for personal use only. If you would like commercial rights to sell any of our models, please subscribe to one of our commercial membership options on thangs or patreon!

https://www.patreon.com/c/LilyFlynnCo

https://thangs.com/designer/Lily%20Flynn%20Co